Every measurement is rounded — learn to state the upper and lower bounds of a rounded value, then combine bounds correctly in sums, differences, products and quotients.
Learning objectives What you will be able to do
Find the lower and upper bounds of a value rounded to any degree of accuracy — nearest unit, decimal places or significant figures.
Write the bounds as a single inequality LB ≤ x < UB, with the correct signs at each end.
Choose the right combination of bounds to find the maximum or minimum of a sum, difference, product or quotient.
Use the two bounds of a calculated answer to state it to a suitable degree of accuracy.
Key words
lower boundupper bounddegree of accuracyhalf unitintervalsignificant figuresmaximumminimum
Starter 5 minutes — before we begin
Answer from memory, then open each one to check.
Starter 1Round 3.6449 to 1 decimal place.
3.6 — the next digit is 4, so the 6 stays as it is.
Starter 2Round 8347 to 2 significant figures.
8300 — the second significant figure is the 3, and the 4 after it rounds it down.
(a) 0.5 (b) 0.05 (c) 50 — you will halve units like these all lesson.
Learn Teach · example · together
1 · Half a unit each way
A ruler marked in centimetres cannot tell you a length exactly. If a pencil is “27 cm to the nearest
centimetre”, its true length sits somewhere in a small interval around 27. The ends of that interval are the
lower bound and upper bound, and the exam expects you to state them precisely.
Definition
For a value rounded to a given degree of accuracy, take half of that unit and go each way:
lower bound = value − half unit, upper bound = value + half unit.
For 27 cm to the nearest cm the unit is 1, half of it is 0.5, so the bounds are 26.5 and 27.5.
The interval on a number line
Why the mixed signs? A value of exactly 26.5 rounds up to 27, so it belongs inside
the interval. A value of exactly 27.5 rounds up to 28, so it does not. The correct
statement is
26.5 ≤ l < 27.5
The upper bound is 27.5, even though the length can never actually equal it
Watch out
Never write the upper bound as 27.49 or 27.4999…. The examiner wants the exact boundary value
27.5, written with a < sign — and 27.5 is still the number
you use in every calculation.
Example 1The length of a rod is 12.4 cm correct to 1 decimal place. Write down an inequality for the true length l.
1
1 decimal place means the value was rounded to the nearest 0.1. Halve that unit.
0.1 ÷ 2 = 0.05
2
Subtract and add the half unit.
12.4 − 0.05 = 12.35 12.4 + 0.05 = 12.45
3
Write it as one inequality: ≤ at the bottom, < at the top.
12.35 ≤ l < 12.45
2 · Spotting the unit
The method never changes: identify the unit the value was rounded to, halve it, go each way. The only
real skill is spotting the unit — especially with significant figures.
Given
Rounded to the nearest…
Half unit
Interval
3400 (nearest 100)
100
50
3350 ≤ x < 3450
27 (nearest whole number)
1
0.5
26.5 ≤ x < 27.5
4.6 (1 dp)
0.1
0.05
4.55 ≤ x < 4.65
0.38 (2 dp)
0.01
0.005
0.375 ≤ x < 0.385
8300 (2 sf)
100
50
8250 ≤ x < 8350
0.007 (1 sf)
0.001
0.0005
0.0065 ≤ x < 0.0075
Exam tip
For significant figures, underline the last significant digit and ask “what is that digit worth?”
In 8300 to 2 sf the last significant digit is the 3, which is worth 300, so the value was
rounded to the nearest 100.
Example 2The mass of a lorry is 8300 kg, correct to 2 significant figures. Write down its lower and upper bounds.
1
The two significant figures are the 8 and the 3. The 3 stands for 300, so the mass was rounded to the nearest 100 kg.
2
Half the unit is 50.
8300 − 50 = 8250 8300 + 50 = 8350
lower bound 8250 kg, upper bound 8350 kg (8250 ≤ m < 8350)
Exam trap Reading 8300 as “nearest 1” gives 8299.5 and 8300.5. Always read the stated degree of accuracy before you touch the numbers.
3 · Calculating with bounds
When rounded measurements are combined, the answer has bounds too. The whole skill is deciding which
bound of each quantity to use — and for a difference or a quotient you have to mix them.
Calculation
Maximum uses
Minimum uses
a + b
UBa + UBb
LBa + LBb
a − b
UBa − LBb
LBa − UBb
a × b
UBa × UBb
LBa × LBb
a ÷ b
UBa ÷ LBb
LBa ÷ UBb
Why a difference mixes the bounds
To make a − b as big as possible, start with as much as possible and take
away as little as possible — upper bound of a, lower bound of
b. Reverse it for the minimum.
Why a quotient mixes them too
A fraction is largest when the numerator is largest and the denominator is smallest — dividing
by a smaller number gives a bigger answer. So the maximum of ab
is UBaLBb.
Watch out
Do not round the bounds themselves. Carry the exact boundary values through the whole calculation and round
only the final answer — to 3 significant figures unless the question says otherwise.
Example 3A rectangle measures 8.4 cm by 5.7 cm, each correct to 1 decimal place. Find the upper and lower bounds of (a) its perimeter, (b) its area.
1
Half unit is 0.05, so write down all four bounds first — setting them out prevents nearly every mistake.
length: 8.35 ≤ l < 8.45 width: 5.65 ≤ w < 5.75
2
(a) Perimeter is a sum, so the largest perimeter comes from the largest sides, the smallest from the smallest.
max P = 2 × (8.45 + 5.75) = 28.4 cm min P = 2 × (8.35 + 5.65) = 28 cm
3
(b) Area is a product: upper × upper and lower × lower.
max A = 8.45 × 5.75 = 48.5875 cm² min A = 8.35 × 5.65 = 47.1775 cm²
(a) 28 cm ≤ P < 28.4 cm (b) 47.1775 cm² ≤ A < 48.5875 cm²
Exam tip Give bounds exactly when they are exact, as here. Rounding 48.5875 to 48.6 turns an upper bound into something the area could actually exceed.
Example 4A runner covers 250 m, measured to the nearest 10 m, in 20 s, measured to the nearest second. Find the upper and lower bounds of her average speed, to 3 significant figures.
1
Bounds of the distance (half unit 5) and the time (half unit 0.5).
245 ≤ d < 255 19.5 ≤ t < 20.5
2
Speed is a quotient, so the fastest speed uses the longest distance in the shortest time.
max speed = 255 ÷ 19.5 = 13.0769…
3
The slowest speed uses the shortest distance in the longest time.
min speed = 245 ÷ 20.5 = 11.9512…
4
Round only now, to 3 significant figures.
min speed = 12.0 m/s max speed = 13.1 m/s (3 sf)
Exam tip Saying “fastest = furthest in the least time” out loud gets the bounds the right way round every time.
Practice Now you try
Do every question on paper first, then open the solution and mark your own working.
Practice 1Write an inequality for the true value of: (a) 36 cm to the nearest cm (b) 4.70 kg to 2 dp (c) 1500 m to the nearest 100 m.
1
Halve each unit: 0.5, 0.005 and 50, then go each way from the rounded value.
(a) 35.5 ≤ x < 36.5 (b) 4.695 ≤ x < 4.705 (c) 1450 ≤ x < 1550
Practice 2The population of a town is 42 000, correct to 2 significant figures. Write down the lower and upper bounds.
1
The second significant figure is the 2, worth 2000 — so the value was rounded to the nearest 1000, and the half unit is 500.
42 000 − 500 = 41 500 42 000 + 500 = 42 500
lower bound 41 500, upper bound 42 500
Practice 3p = 6.3 and q = 2.8, each correct to 1 decimal place. Find the upper bound of p + q and the lower bound of p − q.
1
Bounds first.
6.25 ≤ p < 6.35 2.75 ≤ q < 2.85
2
A sum takes upper + upper; a difference mixes: minimum = lower of p minus upper of q.
UB(p + q) = 6.35 + 2.85 = 9.2 LB(p − q) = 6.25 − 2.85 = 3.4
UB(p + q) = 9.2 LB(p − q) = 3.4
Practice 4A square has side 7.5 cm correct to 1 decimal place. Find the upper and lower bounds of its area.
1
Bounds of the side: 7.45 ≤ s < 7.55.
2
Area is s² — a product of the side with itself, so square each bound.
min A = 7.45² = 55.5025 cm² max A = 7.55² = 57.0025 cm²
55.5025 cm² ≤ A < 57.0025 cm²
Practice 5A car uses 45 litres of fuel, to the nearest litre, to travel 560 km, to the nearest 10 km. Find the maximum possible number of km per litre, to 3 significant figures.
1
Bounds first.
555 ≤ d < 565 44.5 ≤ f < 45.5
2
km per litre is a quotient — the maximum uses the longest distance on the least fuel.
max = 565 ÷ 44.5 = 12.696…
12.7 km per litre (3 sf)
Common mistakes Lose no easy marks
Writing the upper bound as 27.49 or 27.499…
The upper bound is the exact boundary value — 27.5 with a < sign. A string of 9s is
never accepted, and it also gives wrong answers when you calculate with it.
Using upper with upper in a difference or quotient15.65 − 9.25 uses both upper bounds and scores nothing. A difference and a quotient
always mix an upper with a lower — check against the table before you compute.
Rounding bounds part-way through
Carry exact boundary values through the whole calculation. Round once, at the very end, to 3 significant figures
unless the question says otherwise.
Exam tip
Before any bounds calculation, write all four bounds in a little table — LB and
UB for each quantity. It takes ten seconds and prevents nearly every mixing mistake, and the
written bounds are usually worth a method mark on their own.
Exit check Prove it before you leave
Exit 1A crowd is 3400 to the nearest 100. Write down the bounds.
Half unit 50, so 3350 ≤ x < 3450.
Exit 2Which bounds give the maximum of a − b?
UB of a minus LB of b — most possible take away least possible.
Exit 3Write down the upper bound of 4.6, correct to 1 decimal place.